| This is a quick how to install weldless kits instructional page with pictures!! This is a cooler kit install, kettle & thermometer kits are installed roughly the same way!! |
How to install Weldless Kits
Valve with barb & nipple
attached(Teflon tape on all
threads).
attached(Teflon tape on all
threads).
 | |  | |  |
1.
2.
3.
4.
5.
6.
7.
8.
9.
Some have washers on the
outside also but most just use
1 washer inside. Push
assembly into cooler or kettle.
outside also but most just use
1 washer inside. Push
assembly into cooler or kettle.
Nipple inside now.
O-ring installed(Teflon should
be installed under o-ring with
about 5 wraps).
be installed under o-ring with
about 5 wraps).
Place stainless washer onto
nipple.
nipple.
.
Place coupler & tighten by
hand until it seals tight.
hand until it seals tight.
If you are using a copper
downtube or manifold thread
copper adapter in coupler
with Teflon tape on threads.
downtube or manifold thread
copper adapter in coupler
with Teflon tape on threads.
Next install your downtube
or manifold assembly if
applicable. A wrap of
or manifold assembly if
applicable. A wrap of
Finished unit from both
sides. Fill with water &
tighten as needed to seal.
sides. Fill with water &
tighten as needed to seal.
